269 次浏览

I Encountered USB Unknown Device

Now I will continue to say something about the set of DVD-RW driver. After one time that I tested the driver working successfully, I took it out and wanted to use it again. But problem occurred.

After I connected the USB to IDE line to one UBS interface on my computer, I found that the system did not recognize it and there was no diver icon in the page of “My Computer” with a signal of “Unknown Device” in the page of “Device Management”. Then I seek the answer for long time and found that there might be two reasons on my computer. Firstly, I believed that the set of DVD-RW driver was still working well.

One reason was related to the hardware of my computer. In many situations just like that, there might be the problem of the low voltage and driving power of the USB interface. That was right. One interface of mine might be in that way. So I changed to another one I usually put the U storage device into.

Another reason was related to the software or the configuration of the operation system. The USB to IDE line is supported by the protocol of USB 2.0 and the driver version of the USB interfaces on my computer should be matched to the same version. Then I found that in the page of “Device Management” showed that version of the interface with “VIA USB Enhanced Host Controller” while the mouse connected to it is OK. So this might be the second problem and the USB driver version should be updated to “VIA USB 2.0 Enhanced Host Controller” with the supported sys files.

I found one website http://driveragent.com that can test the drivers of the hardware on my computer. After testing, it showed that “VIA USB Enhanced Host Controller” was not the latest and could be updated from Microsoft KB908673 (Problems may occur when you try to transfer files to or from a device that is connected to a USB 2.0 hub in Microsoft Windows XP. You can go to the following page to see the detailed information: http://support.microsoft.com/kb/908673.) But I found that it only give us the updating with English version while the edition with simple Chinese is banned to install.

Then I had to continue to find the updating files and on one forum I found them! The two key sys files: USBEHCI.SYS, USBPORT.SYS can be downloaded on the following page: http://benyouhui.it168.com/thread-462717-1-1.html. Then you can copy these files to the driver file package (Usually the path of C:WindowsSystem32Drivers) or you can update the driver of “VIA USB Enhanced Host Controller” to “VIA USB 2.0 Enhanced Host Controller” with these sys files. (The following picture shows the situation I have updated.)

P.S: Problems may occur when you try to transfer files to or from a device that is connected to a USB 2.0 hub in Microsoft Windows XP

You try to transfer files to or from a device that is connected to a universal serial bus (USB) 2.0 hub in Microsoft Windows XP. When you do this, you may experience one or more of the following symptoms:

When you try to transfer files, the file transfer fails. You may receive an error message about a delayed write failure. The error message that you receive may vary, depending on the device that you are using.

Other USB devices that are connected to the USB 2.0 hub may stop working. You may receive notification that the USB devices have been disconnected or reconnected.

Power may be disabled on USB devices. Then, the devices are reenumerated.

A USB keyboard may stop working correctly. For example, the behavior of keys may be irregular. When you press a key, the key entry may be repeated many times. Alternatively, when you press a key, nothing may occur at all.

Note: Some computers have an internal USB 2.0 hub. For example, a portable computer may have a single USB bus and may use an internal USB hub to provide two or more available USB ports on the computer. Therefore, this issue may occur if the device is connected directly to a USB port on the computer.

This issue may also occur if the device is internal and is connected internally to the internal USB 2.0 hub. For example, this problem might occur if you use a portable computer that has an internal Bluetooth radio that is connected to an internal USB 2.0 hub. When you use this Bluetooth device to transfer the files to another device, you may experience the symptoms that are described in the “Symptoms” section.

附:当您尝试传输文件或从与Microsoft WindowsXPUSB 2.0集线器相连的设备可能出现问题

您尝试传输到或从设备连接到通用串行总线(USB)2.0文件Microsoft WindowsXP中集线器。 这样做, 可能会遇到一个或多个以下症状:

当您尝试传输文件, 文件传输失败。 可能收到错误信息有关延迟写入失败。 与使用该设备, 收到错误信息可能异。

USB 2.0集线器相连其他USB设备可能停止工作。 可能会收到通知,USB设备已被断开或重新连接。

USB设备上可能禁用了电源。 设备然后reenumerated

USB键盘可能停止正常工作。 例如, 键行为可能不规则。 当您按一个键, 可能重复多次。 或者当您按一个键, 根本没发生什么。

注意:某些计算机具有内部 USB 2.0 集线器。 例如, 便携式计算机可能有一个USB总线并可能使用内部USB集线器在计算机上提供两个或多个可用USB端口。 如果设备是连接到计算机上的USB端口直接因此, 发生此问题。

如果设备是内部而且内部是连接到内部USB 2.0集线器还发生此问题。 会例如, 如果您使用便携式计算机具有一个内部Bluetooth无线电连接到内部USB 2.0集线器可能发生此问题。 当您使用此Bluetooth设备将文件传输到另一个设备, 您可能会遇到症状部分所述症状。

欢迎光临我的空间

Copyright(C) 2009 summersnow’s spaces. All Rights Reserved.

发表回复

您的电子邮箱地址不会被公开。 必填项已用 * 标注